If you're a homeowner in New York, boiler leaks may be something you'll have to contend with at some point. A leaking boiler is a potentially serious problem that can lead to less efficient heating, water loss and wasted energy. Boiler leaks can also result in major damage that, if not addressed right away, could necessitate total replacement of your boiler. If you suspect a problem with the heating system in your home in New York, boiler leaks can be detected using a few simple methods.
If you've noticed a problem with your home heating or your hot water supply, a leaking boiler could be to blame. A loss of pressure results in a less efficient heating system; a lack of hot water or a suddenly chilly house are signs that your boiler may be losing pressure, and should be checked. If the pressure gauge on your boiler indicates a pressure level below the normal range (usually less than 0.5 pounds per square inch), the next step is to inspect your boiler for leaks.
The most obvious sign of a boiler leak is water pooling around the base, or forming wet spots on floors or walls near the boiler. Because leaks usually occur when your boiler is hot, however, smaller leaks may evaporate right away. Even if there are no water spots in evidence, there are usually other signs: mineral buildup or corrosion will often occur at the site of a leak, often appearing as white or green deposits. Similarly, a rusty spot is a reliable sign that your boiler is leaking, and needs to be repaired. Pay special attention to joints and fittings where pipes and tubes connect to the boiler, as these are prime areas for leaks.
If you're a homeowner in New York, boiler leaks are serious and should not be ignored. As well as reducing the efficacy of your home's heating system, a leak can cause serious corrosion and rusting that could result in major damage over time. If you suspect a leak in your heating boiler, don't ignore it - check it out!